• About
  • Contact
  • Cookie
  • Disclaimer
  • Privacy Policy
  • Change the purpose of use

Tnhelearning.edu.vn - Various useful general information portal

  • Photo
  • Bio
  • How To
  • Tech

How to fix the laptop that does not receive the wired network quickly

September 29, 2023 by admin Category: Tech

You are viewing the article How to fix the laptop that does not receive the wired network quickly  at Tnhelearning.edu.vn you can quickly access the necessary information in the table of contents of the article below.

In many cases, users need a wired network to make the transmission more stable. However, when using the connection port, there is a problem that affects the work. Don’t worry, the article below will guide you how to fix your laptop not receiving wired network quickly.

Table of Contents

  • Check the wires and ports connected to the Router
  • Re-enable network connection
  • Proceed to reset the static IP for the computer
  • Using the DOS command
  • Bring your laptop to a reputable repair address

Check the wires and ports connected to the Router

One of the frequent reasons why the laptop does not receive the network is because the port connected to the Router has a broken or broken error at some point. You need to observe and check if the two ends of the wire contact with the laptop and the router are rusted.

If there is no error, try plugging the network cable to other ports on the Router, if the computer connects to the wired network successfully, the problem may be in a network port on the Router. In case, the network wire is broken or broken, it should be replaced with a new one.

How to fix the laptop that does not receive the wired network quickly

Re-enable network connection

In case, if the computer is connected to the network cable, but the red X still appears and is displayed in the right corner of the screen in the network status icon and the system tray. At that time, the computer has not received a connection signal or has not been activated before.

READ More:   Top 3 32-inch TVs with attractive promotions during Tet holiday

Dấu X màu đỏ vẫn xuất hiện và hiển thị ở góc phải màn hình

Perform the following steps, to resolve the error:

Step 1: Go to Settings (the cog icon).

Vào Cài đặt

Continue, click Network & Internet.

Nhấn chọn Network & Internet

Step 2: Click Ethernet > Then, click Change adapter options.

Chọn Change adapter options

Step 3: Right- click on your computer’s wired network > Select Enable. After a few seconds, this icon will light up and you should be able to use the network.

 Chọn Enable

Proceed to reset the static IP for the computer

Normally, when connecting to the network, all computers use 1 IP as the exchange and identification code system. However, in the process of using Win, the virus error inadvertently causes the IP to disappear, making the laptop appear to have a problem that does not receive the wired network.

Perform the following steps, to resolve the error:

Step 1: Press Windows + R key combination > Then enter the range ncpa.cpl > Click OK.

Nhập dãy ncpa.cpl

Step 2: Select the wireless network your device is using.

Chọn mạng không dây máy đang dùng

Step 3: In the Networking section, click on Internet Protocol Version 4 (TCP/IPv4) > Click Properties.

Chọn nternet Protocol Version 4 (TCP/IPv4)

Step 4: Click Use the following IP address > Fill in all information such as: IP address, Subnet mask and Default Gateway > Select Use the following DNS server addresses > Fill in all information at Preferred DNS server and Alternate DNS server > Click Validate settings upon exit so Windows can automatically check the new IP address > Click OK.

Nhập đầy đủ các thông số

In case, if you want to transfer the IP to your computer , click Obtain an IP address automatically and Obtain DNS server address automatically.

Chuyển máy về IP động

Using the DOS command

This is one of the highly effective methods in overcoming the situation that the computer does not receive the wired network. Perform the following steps:

READ More:   What is a bicycle sprocket? How many types are there? Pros and cons of each type

Step 1: In the computer’s search bar, enter cmd > Right- click command prompt > Select Run as administrator.

Tại thanh tìm kiếm của máy tính nhập cmd

Step 2: Enter fully and correctly the command netsh winsock reset catalog and the command netsh int ip reset reset.log.

Nhập chính xác lệnh netsh winsock reset catalog và lệnh netsh int ip reset reset.log.

Step 3: Turn off the network, restart the machine, then check if the network is stable.

Khởi động lại máy

Bring your laptop to a reputable repair address

If you have tried all of the above options but the error is still not fixed, please bring the device to a reputable repair center that is trusted by many people to have them check and fix the error. help you.

Mang laptop tới địa chỉ uy tín

Hopefully the article has brought a lot of useful information to you, helping you to know how to fix the laptop that does not receive the wired network quickly. Hope you are succesful.

Thank you for reading this post How to fix the laptop that does not receive the wired network quickly at Tnhelearning.edu.vn You can comment, see more related articles below and hope to help you with interesting information.

Related Search:

Related Posts

How to make delicious, crispy, delicious garlic butter shrimp, simple and easy to do
How to make delicious, crispy, delicious garlic butter shrimp, simple and easy to do
How to make crispy, delicious and simple vinegar dipped squid
How to make crispy, delicious and simple vinegar dipped squid
How to make durian ice cream with a simple blender at home
How to make durian ice cream with a simple blender at home

Category: Tech

Previous Post: « Top 999+ Detroit Tigers Wallpaper Full HD, 4K✅Free to Use
Next Post: Top 999+ Jungkook Aesthetic Wallpaper Full HD, 4K✅Free to Use »

Copyright © 2025 · Tnhelearning.edu.vn - Useful Knowledge