You are viewing the article How to DIY a notebook at home at Tnhelearning.edu.vn you can quickly access the necessary information in the table of contents of the article below.
X
wikiHow is a “wiki” site, which means that many of the articles here are written by multiple authors. To create this article, 50 people, some of whom are anonymous, have edited and improved the article over time.
This article has been viewed 47,480 times.
A homemade notebook would make a great gift for a birthday, wedding or anniversary. This is a great way to create something rustic, unique, and personal. With a few basic ingredients and a little time, you’ll ignite your child’s creativity or surprise the recipient.
Steps
Make a notebook with glue and fabric
Choose the material for the book cover and cut it into two equal pieces. When you’re trying to make a book for the first time, using cardboard is easiest. Once you get used to it, you can switch to wood or cardboard.
- The cover must be 0.6cm wider than the inner pages and 1.25cm longer. If you use printing paper, the cover will have a size of 22x31cm.
Fold 6 sheets of paper in half. Then sew them back at the fold with a tight stitch, remembering to start and end the needle at the same point and the knot on the inside. Thus, you have the spine of the book.
- 0.6cm is the appropriate width for the spine of each stack of papers.
Stack stacks of 6-sheet papers on top of each other. Make sure the stacks of papers are neatly stacked on top of each other. Squeeze the stack of papers down with heavy books and measure the width of the spine now.
- After the stacks are pressed tightly, sew them together using the same sewing pattern as above.
Cut a long piece of fabric. The piece of fabric will be the length of the page and 2cm wider than the spine.
Apply glue to one side of the fabric. Use a lot of glue, but don’t take so much that it melts. Glue the fabric to the spine of the book and pull it tight. Use a ruler to trace the fabric vertically to press the surface flat.
- Place the notebook between 2 pieces of parchment paper and place under one or two heavy books. Wait for the glue to dry. This takes about 20 minutes.
Glue 2 pieces of cardboard to the first and last pages of the notebook. Before doing that, you need to make sure the glue in the fabric is dry. In addition, the two pieces of cardboard must also be lined up, neatly with each other and with the spine of the notebook.
Cut an extra piece of fabric. The length of the fabric should be equal to 2 pieces of cardboard and 2cm wider than the first nappy piece. Wrap fabric glued to the spine of the notebook including the cardboard cover and the first piece of fabric.
- Again, place the notebook between two pieces of stencil and underneath some heavy books. Wait for the glue to dry.
After the glue dries, cut a piece of decorative paper. The paper size will be wider and longer than the cover and spine by 5cm.
Make a crease about 2.5cm on the decorative paper at the top and bottom edges. Cut 4 slits in the paper to fit the spine of the notebook (which can’t be folded), discard the cut pieces of paper.
- Cut the paper so that the nape is evenly wrapped but there is no excess paper at the top or bottom. You now have 4 folded edges – 2 on the top and 2 on the bottom.
- Fold these edges in and glue the inside of the book cover.
Cut 2 pieces of paper. The paper will be 0.6cm narrower than the cover and 1.25cm shorter. Glue the paper to the inner cover to cover the unsightly part of the paper inside and the paper will be glued flush with the spine of the book.
- Once the glue has dried, you can decorate the notebook however you like!
Make a Japanese-style notebook
Prepare material. Everything you need can be bought at a craft store and isn’t too expensive. Wipe down the countertop and focus on the following:
- White paper (30-100 sheets, depending on window thickness)
- 2 cardboard covers
- 2 sheets of beautiful patterned paper (2 different types)
- The ribbon is long, about 6mm . wide
- Punches
- Dry glue
- Drag
- Ruler
- Butterfly clip
Arrange white paper. Depending on the type of notebook you’ll be making, you’ll want a thick or thin notebook to know how many pages it needs. With a photo book, about 30 pages are needed. With a journal, about 50 pages or more are needed.
Take scissors. Cut 2 pieces of cardboard about the same size as the white paper. No size is too big or too small. However, if the notebook is too big, it will be difficult to carry around, so your design is not very reasonable.
- Draw two straight lines on a piece of cardboard. Draw the first straight line from top to bottom, 2.5cm from the left edge. The second line is about 3.5cm from the left edge and is parallel to the first line. Do the same for the remaining pieces of cardboard.
- These two lines are very close to each other. This separates the binding from the body, creating a hinge.
Cut along the two lines just drawn. That means cut the paper about 1.25cm between the two lines. Discard the cut cardboard. You now have 2 pieces of cardboard with 1 piece 2.5cm wide.
- Using a paper cutter is easier to cut than using scissors. If you have a knife, use it.
Make the outer cover of the book. Take two pieces of beautifully patterned paper to decorate the cover and cut based on the size of the book. Each piece of paper will be about 3.5cm longer and wider than the inner page. If your white paper is 20x25cm, you need to cut the decorative paper to 24x29cm.
- Place the piece of paper with the pattern facing down, which means you will only see the white side of the paper. Using a pencil, draw a line 2cm from each edge of the paper.
Stick the cardboard on the patterned paper. Line up the cardboard neatly according to the line you drew in the previous step (that’s why you have to). Remember to apply the glue to the entire surface of the paper, not just the edge. If you use dry glue, you won’t get dirty in this step.
- This is the back cover of the book. The 1.25cm gap on the cardboard you cut out earlier will be the “hinges” to help you open and close the notebook easily.
- Apply glue to the paper if you’re using gift wrapping (or thin patterned paper). This will prevent the paper from wrinkling and swelling and give it time to absorb the moisture in the glue before placing the cardboard on top.
- Do the same for the front cover. Remember to paste so that the pattern shows the right direction!
Fold the edges of the paper. With the cardboard on top of the paper, fold the corners close in. Paste neatly, you will have triangles on the corner of the cardboard.
- After the corners have been folded, next is to fold the edges of the paper. Fold the corners first to create a straight fold with sharp corners. Similar to gift wrapping.
- Fold the remaining edges and glue neatly. Keep the space between the two pieces of cardboard.
Next is the inner cover. Cut two pieces of decorative paper that are 1.25cm smaller than the inner page. If the white paper inside the book is 20x24cm, cut the paper to decorate the inner cover with the size 19x23cm.
Punch two holes in the binding. Depending on the type and amount of material you use, punching holes will be easy or difficult. You should punch holes about 3.5cm from the edge.
- If you don’t have a hole puncher (especially a single puncher) you can use a drill. Before drilling a hole in the table, however, place the notebook on something to make it easier to drill the hole, such as a thick phone book. If using a drill, you should bring the inner cover out so that the hard edge is inside.
- Use butterfly clips to secure the notebook.
Thread the ribbon into the hole in the Japanese way of binding. The ribbon will have to be 6 times the length of the notebook. If your notebook is 15cm long, the ribbon should be 90cm long. When you’re done, you’re done with the notebook!
- Thread the string down from the top hole. Leave some ribbon to the right to tie the bow.
- Thread the end of the string through the same hole as above one more time.
- Thread that end of wire down the hole below.
- Thread the same through the hole below one more time.
- Wrap the ribbon down near the nape of the neck and thread the end through the hole below one more time.
- Pull the end of the string up and thread it through the top hole. (At this time, there will be a cross pattern at the spine of the notebook.)
- Wrap the string over the top corner of the notebook and tie it to the other end for a knot. The knot should cover the top hole.
- Finally, tie a bow.
Advice
- Please measure accurately.
- If you’re making a journal, you can wrap extra string or ribbon around the front cover to attach loose paper or photos to it.
- You can also use old cardboard or wooden materials to make a book cover. Close the window with round hooks, hinges or bolts and nuts
Warning
- Do not stick the pages together. Since it is more difficult to remove the glue than to apply more glue, you need to be careful.
Things you need
Make a notebook with glue and fabric
- Cardboard (or other cardboard)
- Drag
- Ruler
- Needle and thread
- Two kinds of decorative paper
- Printing paper
- Elmer’s Glue or similar craft glue
- Cloth (most effective piece of old cloth)
- Stencils
- Decorations
Make a Japanese-style notebook
- White Paper (30-100 pages)
- 2 cardboard covers
- 2 sheets of decorative paper, with different styles
- Long ribbon – width 6mm
- Punches
- Dry glue
- Drag
- Ruler
- Butterfly clip
X
wikiHow is a “wiki” site, which means that many of the articles here are written by multiple authors. To create this article, 50 people, some of whom are anonymous, have edited and improved the article over time.
This article has been viewed 47,480 times.
A homemade notebook would make a great gift for a birthday, wedding or anniversary. This is a great way to create something rustic, unique, and personal. With a few basic ingredients and a little time, you’ll ignite your child’s creativity or surprise the recipient.
Thank you for reading this post How to DIY a notebook at home at Tnhelearning.edu.vn You can comment, see more related articles below and hope to help you with interesting information.
Related Search: