You are viewing the article How to Unclog a Toilet at Tnhelearning.edu.vn you can quickly access the necessary information in the table of contents of the article below.
wikiHow is a “wiki” site, which means that many of the articles here are written by multiple authors. To create this article, 189 people, some of whom are anonymous, have edited and improved the article over time.
This article has been viewed 7,162 times.
It seems that the toilet is clogged at the most inopportune times. Fortunately, you can handle most blockages yourself without having to pay for a plumbing service. You can unclog with a rubber plunger or household products like hot water, baking soda, and vinegar. For deeper blockages, try using a drain cable or using a wet/dry vacuum to remove them.
Steps
Rubber piston
- The drain valve looks like a circular drain plug attached to a chain.
- The water in the water tank is not dirty, so you can reach in to close the drain valve.
- If the toilet is severely clogged, you need to wear rubber gloves. The toilet is not very clean, but a good pair of gloves will protect you from germs. Choose elbow-length gloves.
- You may also need to wear old clothes to prevent stains.
- If the piston you are using doesn’t seal, try wrapping a rag on the bottom of the piston to prevent leaks.
- Leave the rubber plunger under hot water for a while before using it. Hot water will soften the rubber and help seal.
- Indent the plunger on the toilet hole. Start slow, as the first push will push air down the toilet. Press down, then pull up forcefully to hit the blockage and loosen it. Continue pressing and pulling until the water starts to flow away. You may need to do 15 to 20 enemas before the toilet is unclogged. [2] X Research Source Be patient. As long as you’re sure there’s no hard object stuck underneath, it’s usually enough to just use the piston. You may not see immediate results, but this usually works after several rounds of indentation, about a dozen times each.
Enzyme products
- You can buy these products at home improvement stores or on a pipe display stand. This product is preferred over pipe cleaning chemicals because it does not harm the pipes and the environment. [4] X Research Sources
- This method can only handle organic waste, does not work with toys or other objects.
Do-it-yourself products
- Use at least 2 liters of water. Small amounts of water will not be effective because it does not create enough force to push the clog away.
- The water should not be hotter than the tea you can drink. Do not use boiling water because it can crack the porcelain. You need to increase the temperature for the amount of water to flow through or press on the clog.
- If baking soda and vinegar aren’t available, try adding a few drops of dish soap to the toilet instead. Soap can help loosen the clog. [6] X Research Source
- This method may not work for blockages caused by hard objects, such as toys.
Drain cable
Metal hanger
- Remember to wear gloves when doing this. Maybe water will shoot up when you operate.
- If you can’t feel the obstruction and the toilet won’t drain, it means the object is out of reach of the hanger. You should try using a drain cable to unclog the clog.
Unblocking chemicals
- Do not use chemical solutions if a hard object is suspected. You need to use a cable to unclog the drain or call to repair the pipe.
- Only use chemicals specifically designed for toilets. Other unclogging products can damage the toilet.
- Never use a rubber plunger immediately after pouring chemicals into the toilet. Chemicals can splash on the skin.
- Make sure the bathroom is well ventilated so you don’t breathe in the chemicals.
Wet/dry vacuuming
Advice
- If your toilet is often clogged, try to find out what is causing the blockage and prevent it from happening again. Common culprits are too much discarded toilet paper, tampons (some can slip away, but most don’t), toys (kids and pets), toothpicks. cotton and wet tissue. You should inform the whole family about “do not throw down the toilet” to protect the pipe.
- Take care of hygiene. Use an antiseptic cleaner after unclogging the toilet. Discard the metal rod (if used), disinfect or dispose of rubber gloves and any tools (such as rubber pistons or drain cables) that have been used. These tools can spread germs and give off odors if not cleaned properly. Pistons (especially those with protruding rubber pads) may still have water inside after use. You can leave the plunger above the toilet, tilt it up a bit, and shake it gently to keep the water from dripping onto the floor.
- Before unclogging: If you see (or hear) water in the sink or tub rising every time you flush, there’s an obstruction deep in the pipes and the toilet won’t work properly. . Don’t think about the above methods. Call the plumber.
- Regularly clean around the drain in the toilet so the water can drain at full capacity and help reduce the chance of a blockage. If you haven’t cleaned it in a while, you may need to use a screwdriver and carefully remove any residue.
- An alternative to a rubber piston is a mop with a plastic bag over the mop head.
Warning
- Coat hangers and drain cables can scratch the porcelain in the toilet. You need to be very careful to limit damage, at least in the visible part. The end of the coat hanger that you are going to insert into the toilet to “fish” the obstruction should be bent into a V shape with pliers and then lightly wrapped with electrical tape. Carefully hook onto the obstruction/toy and then gently pull it out with a continuous motion.
- Most unclogging products in retail stores are not specifically designed for toilets. Check the label on the package to make sure the product is suitable for toilet flushing. Remember that some unclogging products give off a lot of heat when the chemicals come in contact with water; This heat can seriously damage the toilet bowl and the plastic pipes attached to it if not handled properly.
- Unblocking chemicals are generally extremely toxic. Avoid contact with skin and eyes, do not mix chemicals. Follow the manufacturer’s instructions exactly and heed any warnings.
- Do not push or pull too hard when using the plunger in the toilet because it is unnecessary and may cause water to splash.
wikiHow is a “wiki” site, which means that many of the articles here are written by multiple authors. To create this article, 189 people, some of whom are anonymous, have edited and improved the article over time.
This article has been viewed 7,162 times.
It seems that the toilet is clogged at the most inopportune times. Fortunately, you can handle most blockages yourself without having to pay for a plumbing service. You can unclog with a rubber plunger or household products like hot water, baking soda, and vinegar. For deeper blockages, try using a drain cable or using a wet/dry vacuum to remove them.
Thank you for reading this post How to Unclog a Toilet at Tnhelearning.edu.vn You can comment, see more related articles below and hope to help you with interesting information.
Related Search: